LW300 V6-3.0L VIN R (2001)
Exhaust Pipe: Service and Repair
Exhaust Manifold Pipe Replacement - Rear
REAR EXHAUST MANIFOLD PIPE
1. Remove exhaust manifold pipe heat shield.
NOTICE: Do not apply grease or silicon products to the heated oxygen sensor. Do not alter the wiring in any way. The wires carry air reference to
the sensor.
2. Remove heated oxygen sensor electrical connector.
3. Remove heated oxygen sensor.
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST.
4. Raise vehicle on hoist.