RELAY AWD V6-3.5L VIN 8 (2005)
Pull the primary seal weatherstrip back, clean and apply two-way tape 130 mm (12 in) long to the weatherstrip lip. Refer to the illustration above. Clean
and then seat the primary seal to the "A" pillar.
Condition # 2
Road noise, windnoise or the windshield fogs up on the right hand side.
Cause
A foaming operation may have been missed at the bottom of the "A" pillar. Open the hood and look for the foam in the illustration shown above.
Correction
From the inside of the vehicle, place duct tape horizontally in the hole so that when the foam is applied, it doesn't drop down into the dash. Apply Kent
Ure-foam(TM) Expandable Foam, P/N P10630, or 3M(TM)Automix(TM) flexible foam, P/N 08463, to the bottom of the "A" pillar. Refer to the
illustration above. Apply a second tube from outside the vehicle. Refer to the foam in the illustration under the cause.
Condition # 3
