saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Vehicle - Trailer/RV and Disabled Vehicle Towing|Page 18838 > < Vehicle - Trailer/RV and Disabled Vehicle Towing|Page 18836
Page 7
background image

Before performing dinghy towing procedures, remove the large IGN fuse from the underhood fuse block. Failure to remove this fuse may result in low
battery voltage after towing.

5AT Five-Speed Automatic Transaxle (MJ7/MJ8) Fluid Check Procedure

Park the vehicle on a level surface.

Shift the vehicle into PARK (P) and apply the parking brake.

Ensure the air conditioning (A/C) is turned "OFF."

Warm the engine to normal operating temperature (76°-80°C [168°-176°F]) until the electric cooling fan mounted on the radiator cycles "ON" at least
once).

With your foot on the brake pedal, move the shift lever through each gear range, pausing for a couple of seconds between each shift lever selection.

Place the shift lever into PARK (P).

Turn the engine OFF.

The transaxle dipstick has a black handle.

Pull out the transaxle dipstick and wipe it clean with a rag or paper towel.

Push transaxle dipstick back in all the way into the transaxle dipstick tube until it seats. Wait 60 seconds, then pull the dipstick out again.

Check both sides of the transaxle dipstick and read the lower level. The fluid must be between the upper and lower mark. If the fluid level is in the
acceptable range, push the dipstick back in the dipstick tube until it seats.

If the fluid level is incorrect, remove or add automatic transaxle fluid as necessary to bring the transaxle to proper fluid level. Always use GM ATF-Z1
automatic transaxle fluid, P/N 22717466. If the required fluid is not available, Dexron(R)III automatic transaxle fluid may be used as a temporary
replacement. Continued use of Dexron(R)III however, can adversely affect shift quality. Have the transaxle flushed and refilled with GM ATF-Z1
automatic transaxle fluid as soon as convenient.

Disabled Towing Information

The Saturn VUE can be towed with car carrier equipment or wheel lift equipment. When wheel lift equipment is used to raise the rear of the vehicle off
the ground, a towing dolly must be installed under the front wheels. When wheel lift equipment is used to raise the front of the vehicle off the ground, a
towing dolly must be installed under the rear wheels. Refer to the appropriate model year General Motors Towing Manual for more information
regarding disabled towing.

Front-wheel drive and all-wheel drive vehicles equipped with the VTi variable transaxle should not be towed with all four wheels on the ground. To tow
these vehicles properly, they should be placed on a platform trailer with all four wheels off the ground.

For vehicles equipped with a 2.2L four-cylinder (L61) engine and VTi variable transaxle, disabled towing is allowed with all four wheels on the ground
in emergency situations, but is limited to 1 mile (1.6 km) at a maximum speed of 5 mph (8 km/h).

Vehicle - Trailer/RV and Disabled Vehicle Towing|Page 18838 > < Vehicle - Trailer/RV and Disabled Vehicle Towing|Page 18836