RELAY AWD V6-3.5L VIN L (2006)
Power Sliding Door Module: Service and Repair
Lock Module Replacement - Sliding Door
LOCK MODULE REPLACEMENT - SLIDING DOOR
REMOVAL PROCEDURE
1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
IMPORTANT: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door
modules (PSDM) will be interrupted and both PSDs will be inoperative.
2. Manually open the power sliding door.
3. Remove the power sliding door water deflector.
4. Remove the forward screws.
5. Remove the lock module screws (1).
6. Disconnect the electrical connector (3).
7. Disconnect the lock rods (4).
8. Lower the lock module into the door.
