RELAY AWD V6-3.5L VIN L (2006)
7. Install the quarter molding to the quarter panel.
8. Press the center flange of the quarter molding into the 2 outer retainers.
9. Press the locating pins into the holes of the quarter panel.
10. Press the center flange of the quarter molding into the remainder of the retainers on the quarter panel.
11. Push the upper portion of the quarter molding inboard over the retainers.
Important: Do NOT touch the adhesive backing.
12. Remove the protective liner from the back side of the quarter molding.
13. Press the bottom of the quarter molding inboard in order to ensure a maximum bond to the quarter panel.
Notice: Refer to Fastener Notice in Cautions and Notices.
14. Install the screws to the rear quarter molding.
Tighten the screws to 2 N.m (18 lb in).
