RELAY AWD V6-3.5L VIN L (2006)
2. Tighten the top screw (1) to 10 N.m (89 lb in).
8. Ensure the rear latch rod is secured into the sliding door insulator guide.
9. Install the water deflector.
10. Close the sliding door.
11. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
IMPORTANT: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be
operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Actuator Control Module - Power
Sliding Door (PSD) Programming and Setup.
