RELAY AWD V6-3.5L VIN L (2006)
11. Fully seat the piston dust boot seal in the seal counterbore.
12. Install the piston dust boot seal retaining ring to the groove in the caliper seal counterbore.
13. Install the brake caliper to the vehicle .Inspect the brake caliper for brake fluid leaks while performing the hydraulic brake system bleeding
procedure after the caliper has been installed to the vehicle. If the brake caliper leaks brake fluid from the FRONT of the caliper past the piston
dust boot seal, replace the caliper piston assembly. The piston integral adjustment mechanism contains a non-serviceable seal which may be
allowing brake fluid to leak past it through a bleed hole near the end of the caliper piston.
Brake Caliper Bracket Replacement - Front
Brake Caliper Bracket Replacement - Front
Removal Procedure
1. Caution: Refer to Brake Dust Caution in Service Precautions.
Notice: Refer to Support the Brake Caliper While Flex Hose is Connected Notice in Service Precautions.
Remove the caliper from the mounting bracket and support the caliper with heavy mechanics wire or equivalent. It is not necessary to disconnect
the hydraulic brake flexible hose from the caliper.
2. Remove the brake pads (5) from the brake caliper bracket (3).
3. Remove the brake pad retainers (4) from the brake caliper bracket.
