RELAY AWD V6-3.5L VIN L (2006)
These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they
become loose or are removed may cause loss of vehicle control and personal injury.
Notice:
Refer to Fastener Notice in Service Precautions.
Install NEW wheel bearing/hub bolts.
Tighten the NEW wheel bearing/hub bolts to 130 Nm (96 ft. lbs.)
3. Install the wheel drive shaft nut.
4. Install the brake rotor.
5. Install the brake caliper bracket with the brake caliper.
6. Important:
Ensure that the connector clip engages the bracket properly.
Install the wheel speed sensor electrical connector to the bracket.
7. Connect the wheel speed sensor electrical connector (2).
8. Install the tire and wheel.
9. Lower the vehicle.
