RELAY AWD V6-3.9L (2007)
Notice: Refer to Fastener Notice.
Important: Position the wiper motor crank arm onto the pivot shaft and ensure the crank arm is positioned between the 2 dimples (2) on
the wiper motor transmission assembly.
1. Once aligned, secure the crank arm nut (4) while holding the crank arm between the 2 motor casting dimples (2).
Tighten the nut to 10 N.m (89 lb in).
2. Using the J 39529, connect the transmission link (1) to the wiper motor crank arm (5).
3. Secure the wiper module. Refer to Wiper Motor Module Replacement.
4. Connect the electrical connector to the wiper motor.
5. Verify the operation of the wiper system.
6. Close the hood.