RELAY FWD V6-3.9L VIN 1 (2006)
1. Connect the sliding door jamb contact plate electrical connector (4).
2. Position the sliding door jamb contact plate (3) to the pillar.
3. Install the sliding door jamb contact plate push-in retainers.
4. Install the lower corner of the water deflector. Refer to Water Deflector Replacement - Sliding Door (See: Rear Door/Rear Door Panel/Service
and Repair) .
Important: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be
operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Acutator Control
Module - Power Sliding Door (PSD) Programming and Setup .
5. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
