RELAY FWD V6-3.9L VIN 1 (2006)
7. Separate the EBCM from the BPMV by gently pulling apart until separated (1).
Installation Procedure
1. Clean the BPMV surface with alcohol using a clean rag.
2. Install the EBCM (1) to the BPMV.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the 6 screws that attaches the EBCM to BPMV.
^
Tighten the top 4 mounting screws to 5 Nm (44 inch lbs.). Tighten screws in an X pattern.
^
Tighten the bottom 2 mounting screws to 5 Nm (44 inch lbs.).
4. Connect the pump motor connector to the bottom of the EBCM.
