RELAY FWD V6-3.9L VIN 1 (2006)
9. Position the heater pipes out of the way.
10. Remove the engine mount strut/engine lift bracket bolts.
11. Remove the engine mount strut/engine lift bracket.
Installation Procedure
1. Position the engine mount strut/engine lift bracket to the cylinder head.
Notice: Refer to Fastener Notice.
2. Install the engine mount strut/engine lift bracket bolts
Tighten the bolts to 50 Nm (37 ft. lbs.).
3. Position the back heater pipe to the throttle body.
4. Install the nuts holding the heater pipes to the throttle body.