RELAY FWD V6-3.9L VIN 1 (2006)
1. If the oil cooler was replaced, install the oil cooler inlet hose to the oil cooler.
2. Position the oil cooler inlet hose clamp at the oil cooler.
3. Install the NEW oil cooler gasket onto the oil cooler.
4. Install the oil cooler and gasket to the oil filter adapter.
5. Notice:
Refer to Fastener Notice in Service Precautions.
Install the oil cooler connector.
Tighten the connector to 25 Nm (18 ft. lbs.).
6. Install the oil cooler inlet hose to the engine fitting.
7. Position the oil cooler inlet hose clamp at the engine.