RELAY FWD V6-3.9L VIN 1 (2006)
INSTALLATION PROCEDURE
1. Install the air temperature actuator lever (3), if necessary.
IMPORTANT: The actuator lever can only be inserted into the door one way.
2. Install the air temperature actuator (2).
3. Install the air temperature actuator bolts/screws (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts/screws to 1.2 N.m (11 lb in).
4. Connect the air temperature actuator electrical connector (7).
5. Install the driver side knee bolster.
6. Re-calibrate the actuators. Refer to Re-Calibrating Actuators See: Testing and Inspection/Programming and Relearning
