RELAY FWD V6-3.9L VIN 1 (2006)
A/C Coupler O-ring: Service and Repair
Sealing Washer Replacement
SEALING WASHER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the seal washer from the A/C refrigerant component.
2. Inspect the seal washer for any signs of damage.
3. Inspect the A/C refrigerant components for damage or burrs. Repair if necessary.
4. Discard the sealing washer.
IMPORTANT: DO NOT reuse sealing washer.
INSTALLATION PROCEDURE
1. Inspect the new seal washer for any signs of cracks, cuts, or damage.Do not use a damaged seal washer.
IMPORTANT: Flat washer type seals do not require lubrication.
2. Using a lint-free clean, dry cloth, clean the sealing surfaces of the A/C refrigerant components.
3. Carefully install the new seal washer onto the A/C refrigerant component.
4. The washer must completely bottom against the surface of the fitting.
5. Assemble the remaining A/C refrigerant components. Refer to the appropriate repair procedure.
IMPORTANT: After tightening the A/C components, there should be a slight sealing washer gap of approximately 1.2 mm (3/64 in) between the
A/C line and the A/C component.
