RELAY FWD V6-3.9L VIN 1 (2006)
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 3.5 N.m (31 lb in).
5. Remove the cap or tape from the A/C lines.
6. Install the new sealing washers onto the A/C line.
7. Install the A/C lines to the auxiliary TXV.
8. Install the auxiliary TXV line block fitting retaining bolt.
Tighten the nut to 11 N.m (97 lb in).
9. Install the auxiliary TXV line clamp to the HVAC module assembly.
10. Install the auxiliary TXV line clamp screw.
Tighten the screw to 1.6 N.m (14 lb in).