RELAY FWD V6-3.9L VIN 1 (2006)
14. Extend the SIR deployment harness and adapter to full length from the deployment fixture.
15. Connect the pretensioner (1) to the adapter (2) on the deployment harness (3).
16. Clear the area of people.
IMPORTANT: The rapid gas expansion involved with deploying a pretensioner is very loud. Notify all the people in the immediate area that you
intend to deploy the seat belt pretensioner.
17. Separate the 2 banana plugs on the SIR deployment harness.
CAUTION: When you are deploying a pretensioner for disposal, perform the deployment procedures in the order listed. Failure to follow the
procedures in the order listed may result in personal injury.
18. Place a 12-volt minimum/2-amp minimum power source, such as a vehicle battery, near the shorted end of the harness.
IMPORTANT: When the seat belt pretensioner deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal reaction of
the seat belt pretensioner due to the force of the rapid expansion of gas inside the pretensioner.
19. Connect the SIR deployment harness wires to the power source. Pretensioner deployment will occur when contact is made.
