RELAY FWD V6-3.9L VIN 1 (2006)
4. Install the idler pulley and bolt on the right front side of the engine.
5. Connect the wire harness to the retainers on the upper and lower right front shock tower.
6. Position the power steering lines and retainer to the stud on the generator bracket.
7. Install the nut holding the power steering lines on the back of the generator.
8. Connect the engine harness electrical connector (3) to the generator.
9. Install the engine harness ground (2) to the generator.
10. Install the engine harness ground nut (1).
Tighten the nut to 30 N.m (22 lb ft).
11. Install the drive belt.
12. Position the engine into the normal location and install the engine mount strut bolts. Refer to Engine Mount Strut Replacement - Left Side and
Engine Mount Strut Replacement - Right Side.
13. Connect the windshield wiper transmission.
14. Install the washer solvent container.
15. Connect the negative battery cable.
