RELAY FWD V6-3.9L VIN 1 (2006)
Important:
Do not apply force to the sensor (1) or the bearing adapter (3) in a sideways direction.
If reusing the sensor, with the pin still installed, align the sensor onto the steering shaft (2) and into the bearing adapter (3).
2. Important:
If installing a new sensor the sensor will come precentered. Do not remove the pin until installation is complete.
Install the sensor onto the steering shaft (2) and into the bearing adapter (3).
3. The sensor must be set to approximately 3 mm gap between the sensor and the bearing adapter.
4. Install the sensor connector.
5. Remove the pin from the sensor.
6. Install the intermediate shaft to the steering column.
7. Install the lower dash insulator and knee bolster.
8. Enable the SIR system. Refer to Restraint System Disabling and Enabling.