SC2 L4-1.9L DOHC VIN 7 (1996)
10.
Install two, 5/16 in. x 1.5 mm thick washers between headlamp housing bracket and upper motor rail, and install headlamp housing to upper motor
rail bolt.
Torque: 10 N.m (89 in-lbs)
11.
Remove front side marker/turn signal/park lamp assembly bolts.
12.
Disconnect lamp sockets and lower front side marker/turn signal/park lamp assembly, and remove from vehicle.
NOTICE:
Remove only the adhesive boilout from the lamp assembly along the bottom edge to the point that is lower than the outboard edge of the amber lens.
Removing too much material may adversely affect the seal of the lamp assembly.
