SC2 L4-1.9L DOHC VIN 7 (1996)
1. If replacing panel:
a. Install clip and trim molding.
b. Install J-clips.
a. Install door lock cylinder bezel.
2. Install foam tape fillers at front edge of outer door panel in locations shown in illustration. Using Kent Industries P/N 40130 1/2" by 9/16" or
equivalent, cut to length and align foam tape to scribe lines on outer door panel for the following:
A=90 mm (3.54 in.)
B=50 mm (1.97 in.)
E=135 mm (5.31 in.)
3. Install foam tape damper in middle of outer door panel using Kent Industries 40140 3/4" x 7/16" or equivalent cut length and align to scribe
lines in center of back side of panel for the following:
D=100 mm (3.94 in.) length
E=100 mm (3.94 in.) length
4. If removed, install foam seal strip to perimeter of door structure using Kent Industries P/N 40105 1/4" x 5/32" or equivalent.
5. Install outer door panel alignment pins into net hole and slot in outer belt reinforcement (door structure).
NOTICE: Apply Loctite(R) 242 Threadlocker (or equivalent) to fasteners before installation.