SC2 L4-1.9L DOHC VIN 7 (1996)
7. Disengage outer seal strip by pulling up at rear end and lifting. Use of a putty knife with blade covered with tape may be needed to gently pry
sealing strip from flange. Remove seal.
8. Remove retainer from handle by prying out center of retainer, then removing retainer. Slide handle off pivot assembly and remove handle.
9. Remove door panel screws and remove door panel.
10. If damaged, remove foam seal strips from perimeter of door structure.
11. If replacing panel:
a. Remove door lock cylinder bezel.
b. Remove J-clips.
c. Remove trim molding and clip.
INSTALLATION
