Sedan L4-1.9L DOHC VIN 7 (1994)
b. Coupe: A = 90mm (3.54 in.),
B = 50mm (1.97 in.) and
C = 135mm (5.31 in.)
3. Install foam tape damper in middle of outer door panel using Kent Industries 40140 3/4 in. x 7/16 in. or equivalent cut length and align to scribe
lines in center of back side of panel for the following:
a. Sedan: C = 100mm (3.94 in.) length
b. Coupe: D = 100mm (3.94 in.) length
E = 100mm (3.94 in.) length
4. If removed, install foam seal strip to perimeter of door structure using Kent Industries P/N 40105 1/4 in. x 5/32 in. or equivalent.
5. Install outer door panel alignment pins into net hole and slot in outer belt reinforcement (door structure).
NOTICE: For 1993 and 1994 vehicles, apply Loctite(R) 242 Threadlocker (or equivalent) to fasteners before installation.
6. On Sedan, install fasteners and tighten in designated sequence.
Torque: 6 Nm (53 in.lbs.)