Sky L4-2.0L Turbo (2008)
8.
Pull the wrench until it clicks. Use the rear edge of the seat as a guide.
^
If the wrench clicks at or less than 45 degrees, the stud is good.
^
If the wrench pulls beyond 45 degrees and does not click, the stud is suspect and needs to be replaced.
Seat Adjuster Stud Removal
Important:
Adjust the seat forward or rearward to access the seat adjuster nuts.
1.
Remove the front and/or rear inboard seat adjuster nuts, as required, from the front driver and/or passenger seats.
2.
Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle in SI.
