Sky L4-2.0L Turbo (2008)
37. If replacing the intake manifold perform the following steps, otherwise proceed to step 11 in the installation procedure.
38. Remove the MAP sensor bolts (1).
39. Remove the MAP sensor (2), ensure that the O-ring seal (3) is still attached on the sensor, if not remove the O-ring seal from the intake manifold.
40. Remove the EVAP purge solenoid bolt (6).
41. Remove the EVAP purge solenoid (5), ensure that the O-ring seal (4) is still attached on the sensor, if not remove the O-ring seal from the intake
manifold.
42. Turn the intake manifold up side down.
43. Remove the throttle body bolts.
44. Remove the throttle body and seal.
Installation Procedure
