Sky L4-2.0L Turbo (2008)
1. Lubricate the solenoid valve O-ring seals with clean engine oil.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the intake (2) CMP actuator solenoid valve and bolt, as required.
Tighten the bolt to 10 N.m (89 lb in).
3. Install the exhaust (1) CMP actuator solenoid valve and bolt, as required.
Tighten the bolt to 10 N.m (89 lb in).
4. Connect the engine wiring harness electrical connector to the intake (1) or exhaust (2) camshaft position actuator solenoid valve, as required.
5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement (See: Intake Manifold/Service and Repair) .
