saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Fuel Pressure Relief (Low Pressure Side with CH 48207)|Page 1687 > < Fuel Pressure Relief (Low Pressure Side with CH 48207)|Page 1685
Page 4
background image

1. Wrap a shop towel around the fuel rail service port.
2. Place the hose on the CH-48027-2 (2) into an approved gasoline container.
3. Open the valve on the CH-48027-2 (2) in order to bleed any fuel from the fuel rail.
4. Close the valve on the CH-48027-2 (2).
5. Remove the hose on the CH-48027-2 (2) from the approved gasoline container.
6. Remove the shop towel from around the fuel rail service port, and place in an approved gasoline container.

Notice:  Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:

*

The fuel pipe connections

*

The hose connections

*

The areas surrounding the connections

2. Disconnect the CH-48027-1 (1) from the CH-48027-2 (2).
3. Disconnect the CH-48027-2 (2) from the CH-48027-3 (4).
4. Disconnect the CH-48027-3 (4) from the fuel rail service port.
5. Install the fuel rail service port cap.
6. Install the engine cover, if required.
7. Tighten the fuel fill cap.

Fuel Pressure Gage Installation and Removal (with CH 48027-100)

Fuel Pressure Gage Installation and Removal (with CH 48027-100)

Special Tools

CH-48027-100 Digital Pressure Gage

Installation Procedure
Caution:
  Refer to Gasoline/Gasoline Vapors Caution  (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel/Service
Precautions/Gasoline/Gasoline Vapors Caution) .

Caution:  Remove the fuel tank cap and relieve the fuel system pressure before servicing the fuel system in order to reduce the risk of personal injury.
After you relieve the fuel system pressure, a small amount of fuel may be released when servicing the fuel lines, the fuel injection pump, or the
connections. In order to reduce the risk of personal injury, cover the fuel system components with a shop towel before disconnection. This will catch any
fuel that may leak out. Place the towel in an approved container when the disconnection is complete.

1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (Low Pressure Side with CH 48207)  (See: Fuel Pressure Relief (Low Pressure Side

with CH 48207))Fuel Pressure Relief (Low Pressure Side with CH 48027-100)  (See: Fuel Pressure Relief (Low Pressure Side with CH
48027-100))Fuel Pressure Relief (Low Pressure Side w/o CH 48207)  (See: Fuel Pressure Relief (Low Pressure Side w/o CH 48207))Fuel

Fuel Pressure Relief (Low Pressure Side with CH 48207)|Page 1687 > < Fuel Pressure Relief (Low Pressure Side with CH 48207)|Page 1685