Sky L4-2.0L Turbo (2008)
17. Remove the pipe clip (1) from the underbody side rail.
18. Remove the pipe clip (2) from the floor panel tunnel brace stud.
19. Remove the pipe clip (3) from the floor panel tunnel brace stud.
20. Remove the pipe clips (4) from the floor panel studs.
21. Remove the fuel feed, EVAP, and brake pipe assembly from the vehicle and place on a suitable work surface.
22. Disconnect the EVAP canister purge line (6) from the EVAP line. Refer to Plastic Collar Quick Connect Fitting Service (See: Fuel Delivery and
Air Induction/Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service) .
23. Remove the retaining clip (1) from the lines.
24. Open the clips (4 and 7), and remove the EVAP line (3) from the clips.
25. Inspect and replace and damaged clips.
Installation Procedure
