Sky L4-2.0L Turbo (2008)
7. This step applies the Sliding retainer style connectors ONLY. Release the fitting by pressing on one side of the release tab causing it to push in
slightly. If the tab does not move, try pressing the tab in from the opposite side. The tab will only move in one direction.
8. This step applies to the Push down TI style connectors ONLY. Release the fitting by pressing on the tab indicated by the arrow.
Caution: Refer to Relieving Fuel Pressure Caution (See: Fuel Pressure/Service Precautions) .
9. Pull the connection apart.
Notice: Use an emery cloth in order to remove rust or burrs from the fuel pipe. Use a radial motion with the fuel pipe end in order to prevent
damage to the O-ring sealing surface.
10. Wipe off the male pipe end using a clean shop towel.
11. Inspect both ends of the fitting for dirt and burrs.
12. Clean or replace the components as required.
Installation Procedure