Sky L4-2.0L Turbo (2008)
10. Remove the 2 rear brake pipe fittings (1) from the brake modulator assembly.
Cap the brake pipe fittings to prevent brake fluid loss and contamination.
11. Remove the 2 front brake pipe fittings (2) from the brake modulator assembly.
Cap the brake pipe fittings to prevent brake fluid loss and contamination.
12. Lift the locking tabs on the lower edge of the EBCM electrical connector (3) and disconnect the electrical connector.
13. Position the EBCM electrical connector and the wiring harness toward the front of the vehicle.
14. Remove the 2 upper brake modulator assembly bracket bolts (1).
15. Loosen, but do not remove the lower BPMV bracket bolt (2).
16. Remove the brake modulator and bracket assembly (3).
