Sky L4-2.0L Turbo (2008)
6. Remove the O-ring seal (3) from the VSS (2).
Installation Procedure
1. Install the O-ring seal (3) to the VSS (2).
2. Install the VSS (2) to the transmission.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the VSS bolt (1).
Tighten the bolt to 17 N.m (13 lb ft).
4. Connect the VSS electrical connector (2).
5. Install the front floor closeout panel. Refer to Floor Panel Tunnel Panel Replacement - Front (Automatic Transmission) (See: Body and
Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Floor Panel Tunnel Panel Replacement - Front (Automatic Transmission)
)Floor Panel Tunnel Panel Replacement - Front (Manual Transmission) (See: Body and Frame/Exterior Moulding / Trim/Underbody
