Sky L4-2.0L Turbo (2008)
7. Remove the shock absorber upper retaining nut.
8. Remove the shock absorber from the shock module.
9. Loosen the compressor forcing screw until the upper mounting plate and the coil spring may be removed.
10. Remove the upper control arm bracket assembly, the insulator, and the coil spring from the spring compressor J 45400 .
Installation Procedure
Important: Ensure the alignment pins in the upper control arm bracket are orientated 90 degrees with the shock absorber lower
mounting holes.
1. Install the coil spring, the insulator, the upper control arm bracket assembly, and the shock absorber to the spring compressor J 45400 , aligning
all marks made in disassembly procedure.
2. Turn the spring compressor forcing screw (1) until the coil spring is compressed.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
