Sky L4-2.0L Turbo (2008)
Seals and Gaskets: Service and Repair
Drive Flange and Seal Replacement
Drive Flange and Seal Replacement
Tools Required
*
J 6125-1B Slide Hammer
*
J-08614-A Pinion Flange Holder and Remover
*
J 23129 Universal Seal Remover
*
J 29873 Injector Nozzle Socket 30 mm
*
J 44765 Seal Installer
*
J 45019 Universal Puller
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
2. Remove the transmission mount. Refer to Transmission Rear Mount Replacement (See: Transmission Mount/Service and Repair) .
3. Remove the transmission manual shift shaft nut (1).
4. Disconnect the shift linkage (2) from the transmission.
5. Place the transmission in neutral by rotating the transmission shift shaft clockwise 2 clicks.
6. Remove the propeller shaft. Refer to Propeller Shaft Replacement (Automatic) (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Propeller Shaft Replacement (Automatic))Propeller Shaft Replacement (RPO ZOK) (See: Drive/Propeller Shafts,
Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Propeller Shaft Replacement (RPO ZOK)) .
