Sky L4-2.0L Turbo (2008)
Important: Support the right rear wheel drive shaft with mechanics wire or equivalent.
22. If servicing the rear differential assembly, remove the rear differential assembly from the vehicle.
Installation Procedure
1. Clean the bolt holes in the differential carrier with brake cleaner or other suitable solvents to remove any adhesive.
2. If servicing the driveline support, position the driveline support (4) on the differential housing.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the bolt plate (3), bolts (2), nuts (1) for the driveline support on the differential housing.
Tighten the nuts to 240 N.m (177 lb ft).
