Sky L4-2.0L Turbo (2008)
1. Clean away all dirt and debris from the transmission fluid fill plug area.
2. Remove the transmission fluid fill plug and washer.
Discard the washer.
3. Fill the transmission to just below the bottom of the fill plug hole with the recommended fluid. Refer to Lubrication Specifications (See:
Specifications/Fluid Type Specifications/Lubrication Specifications) .
4. Install the transmission fluid fill plug and NEW washer.
Tighten the fill plug to 37 N.m (27 lb ft).
5. Install the front floor closeout panel. Refer to Floor Panel Tunnel Panel Replacement - Front (Automatic Transmission) (See: Body and
Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Floor Panel Tunnel Panel Replacement - Front (Automatic Transmission)
)Floor Panel Tunnel Panel Replacement - Front (Manual Transmission) (See: Body and Frame/Exterior Moulding / Trim/Underbody
Cover/Service and Repair/Floor Panel Tunnel Panel Replacement - Front (Manual Transmission)) .
6. Lower the vehicle.
