Sky L4-2.4L (2007)
9. Detach the mechanic's wire from the cable, leaving the wire in position for aid in installation of the cable.
10. Remove the cable from the vehicle.
Installation Procedure
1. Attach the mechanic's wire to the exterior end of the cable.
2. Using the mechanic's wire as an aid, guide the cable underneath the sound insulation and pass the exterior portion of the cable through the cowl
panel.
3. Install the cable to the release handle.
4. Seat the cable grommet to the cowl panel.
5. Install the release handle to the knee bolster.
Notice: Refer to Fastener Notice.
6. Install the screws that retain the release handle to the knee bolster.
Tighten the bolts to 2 N.m (18 lb in).
