saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Body/Tires - Rubbing Noise From Vehicle Rear|Page 14512 > < Body/Tires - Rubbing Noise From Vehicle Rear|Page 14506
Page 1
background image

Rear Fender Liner: Customer Interest
Body/Tires - Rubbing Noise From Vehicle Rear

Bulletin No.: 06-08-65-001

Date: April 28, 2006

TECHNICAL

Subject:
Rubbing Noise from Rear of Vehicle (Install Retainers to Wheel Liner)

Models:
2006 Pontiac Solstice
2007 Saturn Sky

Condition

Some customers may comment on a rubbing noise from the rear of the vehicle.

Cause

This condition may be caused by the inner wheel liner making contact with the tire.

Correction

Install new retainers in the left and right inner wheel liner following the procedure below.

1.

Remove the rear tire and wheel.

2.

Make a measurement from the corner 90 mm (3-1/2 in). The second measurement will be to measure up 40 mm (1-1/2 in). Refer to the illustration.

3.

Drill a hole through the plastic wheel liner and the sheet metal using a 6 mm (15/64 in) drill bit.

4.

Drill the hole larger in the plastic liner using a 8 mm (19/64 in) drill bit to eliminate contact with the retainer.

5.

Apply SuperLube(R) with PTFE, P/N 12371287 (in Canada, P/N 10953437), to the end of the retainer and install the new retainer. You must push
firmly on the retainer to fully seat it.

6.

Install the wheel and tire.

Body/Tires - Rubbing Noise From Vehicle Rear|Page 14512 > < Body/Tires - Rubbing Noise From Vehicle Rear|Page 14506