Sky L4-2.4L (2007)
4. Loosen and adjust the locator pins and install the CH-47960 to the rear knuckle gage holes.
Important: The larger bushing closest to the ball joint affects camber while the smaller bushing towards the front of the vehicle affects
caster.
5. Loosen the lower control arm cam bolt nuts.
6. Rotate the cam bolts to the required camber setting (1).Maintain the camber settings while tightening the cam bolt nuts. Refer to Wheel Alignment
Specifications.
7. Rotate the cam bolts to the required caster setting (2).Maintain the caster settings while tightening the cam bolt nuts. Refer to Wheel Alignment
Specifications.
Notice: Refer to Fastener Notice.
8. Maintain the caster or camber setting while tightening the cam bolt nuts.
Tighten the front control arm cam bolts to 165 N.m (122 lb ft).
