Sky L4-2.4L (2007)
3. If the inspection of the wiring harness reveals a condition that may allow the wiring to short to ground, replace the steering wheel inflatable
restraint module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement in SI for replacement procedures.
4. With the steering wheel inflatable restraint removed, use the following steps to install a piece of adhesive-backed flocking material to the stamped
steel horn plate in order to prevent future damage to the SIR wiring harness.
1. Prepare a 15 mm (19/32 in) X 70 mm (2-3/4 in) piece of adhesive-backed flocking material (such as Kent Industries Part KY13487* or the
equivalent).
2. Install the flocking material to the stamped steel horn plate as shown. Center the length of the flocking material on the horizontal edge of the
opening in the horn plate. Ensure that 5-7 mm (1/4 in) of the flocking material overlaps the front and back of the horn plate. The flocking
material must cover the complete length of the horizontal opening. Press (pinch) along the length of the flocking material to ensure adhesion to
the horn plate.
5. Install the steering wheel inflatable restraint module. Refer to Steering Wheel Inflatable Restraint Module Replacement in SI.
* We believe this source and their products to be reliable. There may be additional manufacturers of such products/materials. General Motors does not
endorse, indicate any preference for, or assume any responsibility for the products or material from this firm or for any such items that may be available
from other sources.
Parts Information
This product is currently available from Kent Industries (1-888-YES-KENT).
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer