Sky L4-2.4L (2007)
Important: Ensure the alignment pins in the upper control arm bracket are orientated 90 degrees with the shock absorber lower
mounting holes.
1. Install the coil spring, the insulator, the upper control arm bracket assembly, and the shock absorber to the spring compressor J 45400, aligning all
marks made in disassembly procedure.
2. Turn the spring compressor forcing screw (1) until the coil spring is compressed.
Notice: Refer to Fastener Notice.
3. Install the shock absorber retaining nut.
Tighten the nut to 42 N.m (31 lb ft).
4. Remove the shock module from the spring compressor J 45400.
5. Install the shock module to the vehicle.
6. Install the tire and wheel.
