Sky L4-2.4L (2007)
6. Clean the thread adhesive from the flywheel bolt holes. Use a nylon bristle brush to clean the holes in the crankshaft.
7. Remove the flywheel bolts, if equipped with a manual transmission.
8. Remove the flywheel.
9. Clean the thread adhesive from the flywheel bolt holes. Use a nylon bristle brush to clean the holes in the crankshaft.
Installation Procedure
1. Install the flywheel, if equipped with a manual transmission.
Notice: Refer to Fastener Notice.
2. Install the flywheel bolts.
Tighten the bolts to 53 N.m (39 lb ft) plus an additional 25 degrees using the J 45059.
