SL L4-1.9L DOHC VIN 7 (1992)
Torque: 30 N.m (22 ft-lbs)
4. Install pulley on pump hub. The pulley can be held using a strap wrench, block of wood or hammer handle.
Torque: 25 N.m (19 ft-lbs)
IMPORTANT: If the pump pulley hub end extending through the pulley is rusty, clean it with a wire brush and apply a thin coat of primer paint to
prevent the pulley from rusting on the hub.
5. Install accessory drive belt. (Reference "Engine Drive Belt" and "Accessories".) See: Drive Belts, Mounts, Brackets and Accessories
6. Install right hand splash shield and tire.
7. Close radiator drain plug and install cylinder block drain plug.
Cylinder block drain plug Torque: 35 No.m (26 ft-lbs)
NOTICE: The vehicle must be level when filing with coolant.
8. Remove pressure cap and fill the system with coolant. Use only a non phosphate ethylene glycol-base coolant, mixed according to the
manufacturer's directions. See: Cooling System
9. Start engine.
10. Fill the cooling system surge tank to the FULL COLD line after engine has run two to three minutes. Install pressure cap and check for leaks.
