SL L4-1.9L DOHC VIN 7 (1992)
9. Remove three Coil screws.
Good Advice: To enable easier removal of the screws, lightly tap on the end of the screwdriver with a plastic hammer before removal.
10. Disconnect coil wire connector.
INSTALLATION
IMPORTANT: Install clutch coil in same position as removed.
1. Install the three coil screws.
Torque: 3.9-5.9 N.m (35-52 in-lbs)
2. Connect the coil wire to harness.
3. Install pulley installation bolt, drive plate installer SA9149AC-3 and thrust bearing assembly through the center of the pulley. Thread pulley
installation bolt into the end of compressor shaft finger tight.
