saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Fuel Pressure Test - Revision|Page 3365 > < Linear Exhaust Gas Recirculation (EGR) Module <--> [EGR Control Module]|Description and Operation|Page 3359
Page 1
background image

Fuel Pressure: Technical Service Bulletins
Fuel Pressure Test - Revision

NO.: 91-T-51

DATE: December, 1991

GROUP: Engine

CORP NO.: 186302

SUBJECT:
Service Manual Update Fuel/Air Intake/Exhaust (Revised Fuel System Pressure Test Procedure) 1991-1992 Saturns

PURPOSE:
The "Fuel System Pressure Test" procedure located on pages 16 and 17 of the 1991-1992 "Fuel/Air Intake/Exhaust Service Manual" was printed
incorrectly. Included in this bulletin are two stickers. One sticker has a new chart and new steps 3, 4 and 4a., that should be placed on the bottom of page
16. The other sticker, which is blank, should be placed on page 17 over step 10 and the "Important" information steps that follow step 10. (Refer to the
illustration for correct sticker placement.)

3.

Install bleed hose into an approved container and open shut-off valve to bleed off any fuel in the system.

4.

Close the fuel pressure gauge shut-off valve.

a.

Turn ignition key to ON position (do not start engine) and record maximum pressure. Cycle the key on and off several times to establish an
accurate reading. Allow gage pressure to stabilize for thirty second. Refer to readings in illustration.

Fuel Pressure Test - Revision|Page 3365 > < Linear Exhaust Gas Recirculation (EGR) Module <--> [EGR Control Module]|Description and Operation|Page 3359