saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Engine - Misses During All Driving Conditions|Page 3786 > < Crankshaft Position Sensor|Locations|Page 3777
Page 1
background image

Spark Plug Wire: All Technical Service Bulletins
Engine - Misses During All Driving Conditions

NO.: 91-T-42

DATE:

November, 1991

GROUP:

Engine

CORP. NO.: 186405

SUBJECT:

Engine Misses During All Driving Conditions (Install New Spark Plug Wire Clips)

MODELS
AFFECTED:

1991 and 1992 SL2 and SC Saturn vehicles with DOHC (LLO) engines

CONDITION:

Engine misses during all driving conditions.

CAUSE:

The number one spark plug wire may contact the hood insulator and/or the spark plug wire harness may contact the camshaft cover,
damaging the insulation on the spark plug wire(s). If this insulation becomes damaged, a short to ground can result causing an
engine miss.

CORRECTIVE
ACTION:

Inspect the number one spark plug wire and hood insulator for signs of contact. Also, inspect the spark plug wire harness at the
camshaft cover for signs of contact. If there is indication of rubbing damage to any spark plug wire, replace the damaged wire(s)
and install new spark plug holding clips according to the following procedure.

NOTE: The 4-way spark plug wire clip (P/N 12034561) is designed so that it can be cut in half and used to retain two spark plug
wires instead of four.

If there is no evidence of spark plug damage, refer to the "Electronic Engine Controls Service Manual" for diagnostic procedures to
correct the concern.

PROCEDURE:
1.

Inspect the # 1 spark plug wire for evidence of damage or contact with the hood insulator. If there is any evidence of damage or contact, install a
4-way spark plug wire clip (P/N 12034561). Before installing the clip, cut it into two equal parts and smooth out the cut end. Horizontally install
this half of the clip approximately 50 mm (2 in.) from # 2 spark plug boot (refer to Figure). Replace spark plug wire if there is evidence of damage
to the wire.

2.

Inspect the spark plug wire harness for evidence of damage or contact with the camshaft cover. If there is any exidence of damage or contact,
install a 4-way spark plug wire clip (P/N 12034561). Replace any damaged spark plug wires. Refer to the following Figure for correct clip location

Engine - Misses During All Driving Conditions|Page 3786 > < Crankshaft Position Sensor|Locations|Page 3777