SL L4-1.9L DOHC VIN 7 (1992)
Starter Motor: Technical Service Bulletins
Starter Motor - Design Change, Service Information
BULLETIN NO.: 95-T-05
ISSUE DATE: January, 1995
GROUP/SEQ. NO.: Electrical-01
CORPORATION NO.: 586401
SUBJECT:
Service Information on Starter Motor Design Change
MODELS AFFECTED:
1991-1995 Saturns
PURPOSE:
This bulletin provides information on a design change to the starter motor assembly including VIN breakpoints and the impact of the change on
serviceability.
Due to a supplier change, a new 3rd design starter motor assembly is being used on vehicles built after and including VIN SZ197523. In addition, some
vehicles between VINs SZ169984 and SZ172911 also were built with the new 3rd design starter motor assembly.
There have been three different starter motor assemblies used on Saturn vehicles. The following information describes these three design starter motor
assemblies and any additional parts required when servicing them.
3rd Design Starter Motor Assembly P/N 21023232
^
When installing a 3rd design starter motor assembly on a vehicle that was equipped with a 2nd design starter motor assembly, the starter motor splash
shield and starter splash shield retainer are not required.
^
When installing a 3rd design starter motor assembly on a vehicle that was equipped with a 1st design starter motor assembly, the rear starter bracket
is not required. However, the generator wiring harness assembly must be replaced with new longer generator wiring harness assembly (P/N
21022756).
2nd Design Starter Motor Assembly P/N 21020761
^
When installing a 2nd design starter motor assembly on a vehicle that was equipped with a 1st design starter motor assembly, the rear starter bracket
is not required. However, the generator wiring harness assembly must be replaced with new longer generator wiring harness assembly (P/N
21022756).
