SL L4-1.9L SOHC VIN 8 (1997)
1.
Inspect butyl sealer placed around copper drive cable tubes as they exit the front of the module for water leaks. If the water leak occurs from this
area, apply Kent Industries Seal n' Caulk (P/N 10310), or equivalent, as needed until the leak is corrected.
2.
Inspect for leakage where the sides of the sunroof module are joined to the front of the module. Inspect for cracked module. If no cracks are
present, apply a bead of Kent Industries HIGH TECH Seam Sealer (P/N 10070), or equivalent, as shown in the illustration. If cracks are present,
replace module.
3.
Water test vehicle in sunroof module area.
Rear Sunroof Module Hoses and Seals
Rear Sunroof Module Drain Hoses - Sedan
1.
Remove roof rear panel assemblies (rear roof applique's) from the left and right side of vehicle.
^
On 1996 - 1999 model year vehicles, refer to "Panel-Roof Rear Outer-Sedan" in the Roof, Rocker Panels and Attaching Components section
of the appropriate model year Body/Repair Service Manual.
^
On 2000 - 2001 model year vehicles, refer to "Panel-Roof Rear Outer-Sedan" in the Roof and Rockers section of the appropriate model year
S-Series Body/Electrical Volume I Service Manual.
2.
Remove the quarter outer panel hole plugs on the left and right side of the vehicle. (Quarter outer panel hole plugs are located under the rear of the
roof rear panel assembly.)
