SL L4-1.9L SOHC VIN 8 (1997)
^
If water runs over the rear portion of the sunroof module during the water test, remove the sunroof housing rear drain hoses from the vehicle
and proceed to step 3.
^
If water does not run over the rear portion of the sunroof housing during the water test, refer to the other procedures in this bulletin.
3.
Using a standard air gun, limited to 207 kPa (30 psi), blow into the sunroof housing rear drain hoses - to dislodge any possible obstructions.
4.
Reattach sunroof housing rear drain hoses to sunroof housing and water test the vehicle again.
^
If water runs over the rear portion of the sunroof module during the water test, proceed to step 5.
^
If water does not run over the rear portion of the sunroof housing during the water test, the obstruction has been removed.
5.
Replace the sunroof housing rear drain hoses with new sunroof housing rear drain hoses and sunroof housing drain hose clamp(s).
On 1996 - 1999 model year vehicles, refer to "Rear Drain Hose Grommet-Coupe" in the Vehicle Interior Systems section of the appropriate model
year Body/Repair Service Manual.
On 2000 - 2001 model year vehicles, refer to "Rear Drain Hose/Grommet - Coupe" in the Sunroof section of the appropriate model year S-Series
Body/Electrical Volume II Service Manual.
6.
Water test vehicle in sunroof module area.
Reseal Rear of Sunroof Module - All Models
A water leak from the rear of the sunroof module may result from a void in body sealer between sunroof module side rail and end piece that drain hose
attaches to. Before attempting this repair, be certain water leak is not present due to missing hose clamps on sunroof module drain hoses.
1.
Remove sunroof module from vehicle.
2.
From the top side, seal end piece in areas shown in illustration using Kent Industries HIGH TECH Seam Sealer (P/N 10070), or equivalent.
