SL L4-1.9L SOHC VIN 8 (1997)
Brake Bleeding: Service and Repair
Bleeding ABS Equipped Vehicles
Pressure Bleeding (Preferred)
CAUTION:
^
Use only DOT 3 brake fluid from a clean, sealed container. Do not use any fluid from a container which is wet with water. Do not use DOT 5
silicone fluid.
^
Pressure bleeding equipment must be of the diaphragm type. It must have a rubber diaphragm between the air supply and the brake fluid to prevent
air, moisture, and other contaminants from entering the hydraulic system.
^
Prior to bleeding the rear brakes, the rear displacement cylinder pistons must be returned to the top most position or HOME. To return the pistons
to home (top most position), use PDT or equivalent to perform SPECIAL TEST, RUN ABS MOTORS, PISTON UP-HOME. This test will run
the piston to the top of their travel.
1. Clean brake fluid reservoir cap and area around cap. Remove cap.
2. Fill the master cylinder reservoir with clean brake fluid.
3. Install bleeder adapter (SA915OBR) or equivalent to the brake fluid reservoir.
4. Connect pressure bleeder to adapter.
5. Charge pressure bleeder equipment to 207-242 kPa (30-35 psi).
6. Bleed brake modulator assembly.
