SL L4-1.9L SOHC VIN 8 (1997)
12. Removal of front cover assembly. Install the crankshaft timing gear service tool to make sure the front crankshaft timing sprocket is held firmly in
place. Install the service tool with the flat side towards the crankshaft sprocket.
CAUTION: Failure to hold the crankshaft timing sprocket in place will cause timing chain guide damage. The tool also aligns the gerotor during
front cover installation. After the front cover assembly is loosened and moved approximately 25.4 mm (1 inch) from the engine, the crankshaft
timing gear service tool should be removed.
NOTE: Spray the two dowel pin holes in the front cover with penetrating oil to facilitate cover removal off the dowel pins.
13. Remove the four front oil pan bolts and 14 front cover bolts:
a. Use RTV cutter service tool to cut the oil pan seal away from the front cover.
NOTE: After the front cover assembly is loosened and moved approximately 25.4 mm (1 inch) from the engine, the crankshaft timing gear
service tool should be removed.
b. Remove the front cover bolts.
